Brand: HUSKY
Category: Powerwasher
Manual Type:
Language:
Manual for Husky 1800 US - Troubleshooting and error codes + PDF Download
Uploaded: March 29, 2025, 1:56 p.m.
Manual Publish Date: 2006-01-01
Warranty Summary
This product is warranted against defects in material and workmanship for a period of three years on the motor and pump group.
Installation:
- Remove water plug from high pressure outlet.
- Connect high pressure hose, ensuring threads are aligned.
- Connect garden hose.
- Insert wand into spray gun.
- Connect garden hose to water supply and open valve fully.
- Plug into GFCI and press RESET button.
- Squeeze and hold trigger until water flow is steady, then release.
- Press "ON" button and squeeze trigger to start motor and water flow.
Troubleshooting and error codes
| PROBLEM OR CONCERN | POSSIBLE CAUSE | SOLUTION |
|---|---|---|
| Detergent Leak | Disconnected or Kinked Detergent Pick up Tube | Remove the front cover of the unit and check if the clear tube is still properly attached or kinked. If it is not attached then reconnect it or unkink it. |
| Reservoir Tank won't hold Detergent | Chemical Tank Nipple Broken | The Chemical Tank Nipple is attached to the inside wall of the Reservoir Tank. If it is broken you can order a replacement by emailing us at: [email protected]. |
| Detergent is not dispensing | Incorrect wand is attached to the Gun | Make sure that the Adjustable wand is attached to the Gun. Detergent will not dispense with the Turbo Wand or at the high pressure setting. |
| Detergent is not dispensing (Continued) | Wand is not set the low pressure setting | Hold the shaft of the Wand in one hand and turn the gray dial all the way clockwise with the other hand. If the dial is left even slightly in the counter-clockwise direction it will not dispense detergent. |
| Detergent is not dispensing (Continued) | Nozzle is clogged with debris | Turn the Nozzle Head until the two metal blades move apart completely. Straighten out a paper clip and insert it into the tip of the Nozzle. Back flush the Nozzle with water. (see section 5.2) |
Troubleshooting and error codes
| PROBLEM OR CONCERN | POSSIBLE CAUSE | SOLUTION |
|---|---|---|
| Detergent Leak | Disconnected or Kinked Detergent Pick up Tube | Remove the front cover of the unit and check if the clear tube is still properly attached or kinked. If it is not attached then reconnect it or unkink it. |
| Reservoir Tank won't hold Detergent | Chemical Tank Nipple Broken | The Chemical Tank Nipple is attached to the inside wall of the Reservoir Tank. If it is broken you can order a replacement by emailing us at: [email protected]. |
| Detergent is not dispensing | Incorrect wand is attached to the Gun | Make sure that the Adjustable wand is attached to the Gun. Detergent will not dispense with the Turbo Wand or at the high pressure setting. |
| Detergent is not dispensing (Continued) | Wand is not set the low pressure setting | Hold the shaft of the Wand in one hand and turn the gray dial all the way clockwise with the other hand. If the dial is left even slightly in the counter-clockwise direction it will not dispense detergent. |
| Detergent is not dispensing (Continued) | Nozzle is clogged with debris | Turn the Nozzle Head until the two metal blades move apart completely. Straighten out a paper clip and insert it into the tip of the Nozzle. Back flush the Nozzle with water. (see section 5.2) |