Brand: ZANUSSI
Category: Refrigerator
Document Type: Manual
Language: EN
Manual for ZRB34315WA
Uploaded: Nov. 21, 2025, 6:14 p.m.
- Switching on: Insert the plug into the wall socket.
- Temperature regulation: Touch the temperature regulator button until the desired temperature LED lights up (2°C to 8°C). The setting is progressive.
- QuickChill function: Press the QuickChill button to activate for rapid cooling. The corresponding LED lights up. Press again to deactivate. This function stops automatically after 52 hours.
- First use: Clean the interior and accessories with lukewarm water and neutral soap.
Troubleshooting and error codes
| Problem | Possible cause | Solution |
| The appliance is noisy. | The appliance is not installed properly. | Check if the appliance stands stable (all the feet should be on the floor). |
| The appliance does not operate. | The plug is not connected to the mains socket correctly. | Connect the plug to the mains socket correctly. |
| The appliance has no power. There is no voltage in the mains socket. | Connect a different electrical appliance to the mains socket. | |
| The light device does not work. | The light device is in stand-by. | Close and open the door. |
| The unit is defective. | Refer to "Replacing the control unit". | |
| The compressor operates continually. | The temperature is not set correctly. | Set a higher temperature. |
| The door is not closed correctly. | Refer to "Closing the door". | |
| The door has been opened too frequently. | Do not keep the door open longer than necessary. | |
| The food temperature is too high. | Let the food temperature decrease to room temperature before storage. | |
| Water flows on the rear plate of the refrigerator. | The room temperature is too high. | Decrease the room temperature. |
| During the automatic defrosting process, frost defrosts on the rear plate. | This is correct. | |
| Water flows into the refrigerator. | The water outlet is clogged. | Clean the water outlet. |
| Products prevent that water flows into the water collector. | Make sure that products do not touch the rear plate. | |
| The temperature in the appliance is too low/high. | The temperature regulator is not set correctly. | Set a higher/lower temperature. |