Brand: ZANUSSI
Category: Refrigerator
Document Type: Manual
Language: EN
Brand: ZANUSSI
Category: Refrigerator
Document Type: Manual
Language: EN
Uploaded: Nov. 21, 2025, 9:26 p.m.
| Problem | Possible cause | Solution |
|---|---|---|
| The appliance does not operate. | The appliance is switched off. | Switch on the appliance. |
| The appliance does not operate. | The mains plug is not connected to the mains socket correctly. | Connect the mains plug to the mains socket correctly. |
| The appliance does not operate. | There is no voltage in the mains socket. | Connect a different electrical appliance to the mains socket. Contact a qualified electrician. |
| The appliance is noisy. | The appliance is not supported properly. | Check if the appliance stands stable. |
| The compressor operates continually. | Temperature is set incorrectly. | Refer to "Operation" chapter. |
| The compressor operates continually. | Many food products were put in at the same time. | Wait some hours and then check the temperature again. |
| The compressor operates continually. | The room temperature is too high. | Refer to climate class chart on the rating plate. |
| The compressor operates continually. | Food products placed in the appliance were too warm. | Allow food products to cool to room temperature before storing. |
| The compressor operates continually. | The door is not closed correctly. | Refer to "Closing the door". |
| The compressor operates continually. | The water drainage plug is not correctly positioned. | Position the water drainage plug in the correct way. |
| The compressor operates continually. | Food products are not wrapped properly. | Wrap the food products better. |
| Water flows inside the refrigerator. | Temperature is set incorrectly. | Refer to "Operation" chapter. |
| Water flows inside the refrigerator. | The water outlet is clogged. | Clean the water outlet. |
| Water flows inside the refrigerator. | Food products prevent that water flows into the water collector. | Make sure that food products do not touch the rear plate. |
| Water flows on the floor. | The melting water outlet is not connected to the evaporative tray above the compressor. | Attach the melting water outlet to the evaporative tray. |
| The temperature in the appliance is too low/too high. | The temperature regulator is not set correctly. | Set a higher/lower temperature. |
| The temperature in the appliance is too low/too high. | The door is not closed correctly. | Refer to "Closing the door". |
| The temperature in the appliance is too low/too high. | The food products' temperature is too high. | Let the food products temperature decrease to room temperature before storage. |
| The temperature in the appliance is too low/too high. | Many food products are stored at the same time. | Store less food products at the same time. |
| The temperature in the appliance is too low/too high. | The thickness of the frost is greater than 4-5 mm. | Defrost the appliance. |
| The temperature in the appliance is too low/too high. | The door has been opened often. | Open the door only if necessary. |
| There is no cold air circulation in the appliance. | There is no cold air circulation in the appliance. | Make sure that there is cold air circulation in the appliance. |