Manual for ZDT21006FA

Manual for ZDT21006FA

Brand: ZANUSSI

Category: Dishwasher

Document Type: Manual

Language: EN

Uploaded: Nov. 21, 2025, 8:41 p.m.

Warranty Information

No warranty information is available in this document.

Daily Use

  1. Open the water tap.
  2. Press the on/off button to activate the appliance. Ensure the appliance is in programme selection mode.
  3. Load the baskets.
  4. Add detergent.
  5. Set and start the correct programme.

Fill salt and rinse aid containers if indicators are on.

Starting a Programme

  1. Keep the appliance door ajar.
  2. Press the on/off button.
  3. Press the programme button until the desired programme indicator flashes.
  4. Close the door to start.

End of Programme

When the programme is completed, the end indicator is on. Press the on/off button or open the door to deactivate. Close the water tap.

Troubleshooting and error codes

Problem and alarm code Possible cause and solution
You cannot activate the appliance.
  • Make sure that the mains plug is connected to the mains socket.
  • Make sure that there is no damaged fuse in the fuse box.
The programme does not start.
  • Make sure that the appliance door is closed.
  • If the delay start is set, cancel the setting or wait for the end of the countdown.
The appliance does not fill with water.
The end indicator flashes 1 time intermittently.
Acoustic signal sounds 1 time intermittently.
  • Make sure that the water tap is open.
  • Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority.
  • Make sure that the water tap is not clogged.
  • Make sure that the filter in the inlet hose is not clogged.
  • Make sure that the inlet hose has no kinks or bends.
The appliance does not drain the water.
The end indicator flashes 2 times intermittently.
Acoustic signal sounds 2 times intermittently.
  • Make sure that the sink spigot is not clogged.
  • Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
The end indicator flashes 3 times intermittently.
Acoustic signal sounds 3 times intermittently.		 Close the water tap and contact an Authorised Service Centre.
The appliance stops and starts more times during operation. It is normal. It provides optimal cleaning results and energy savings.
The program lasts too long.
  • If the delayed start option is set, cancel the delay setting or wait for the end of the countdown.
Small leak from the appliance door.
  • The appliance is not levelled. Loosen or tighten the adjustable feet (if applicable).
  • The appliance door is not centred on the tub. Adjust the rear foot (if applicable).
The appliance door is difficult to close.
  • The appliance is not levelled. Loosen or tighten the adjustable feet (if applicable).
  • Parts of the tableware are protruding from the baskets.
  • The tableware is not properly arranged in the baskets. Refer to basket loading leaflet.
  • Make sure that the spray arms can rotate freely.
Rattling/knocking sounds from inside the appliance.
  • The tableware is not properly arranged in the baskets. Refer to basket loading leaflet.
  • Make sure that the spray arms can rotate freely.
The appliance trips the circuit-beaker.
  • The amperage is insufficient to supply simultaneously all the appliances in use. Check the socket amperage and the capacity of the meter or turn off one of the appliances in use.
  • Internal electrical fault of the appliance. Contact an Authorised Service Centre.
Privacy Policy