Brand: SHARP
Category: Home Appliances
Document Type: Manual
Language: EN
Manual for QW-NS1CF49EW-EN
Uploaded: Nov. 21, 2025, 8:30 p.m.
Warranty Information
Contact information for customer service can be found on the back of this document.
- Preparing for First Use: Ensure electricity and water match specifications. Remove packaging. Set water softener level and fill rinse aid.
- Salt Usage: Use special dishwasher salt. Fill salt compartment with salt and water on first use. Refill as needed.
- Detergent Use: Use only dishwasher-specific detergents. Do not overfill. Adjust amount based on cycle, load, and soil level.
- Rinse-Aid Use: Helps drying without streaks. Fill compartment and adjust level as needed.
- Loading: Follow guidelines for best results. Remove coarse residue. Do not overload. Place cutlery with sharp points down. Avoid obstructing spray arms and detergent dispenser.
- Programs: Select program based on soil level and desired wash time (Quick 30', Eco, Super 50', Intensive 65°C, Auto).
- Control Panel: Use buttons to control power, select programs, set delay start, activate options (Tablet, Half Load), and monitor progress.
- Cleaning & Maintenance: Regularly clean filters, spray arms, and drain pump. Wipe door seals. Run empty cycle for oil/limescale buildup.
- Troubleshooting: Consult the table for common faults and their solutions.
Troubleshooting and error codes
| The programme does not start. | Your Dishwasher is not plugged in. | Plug your Dishwasher in. |
|---|---|---|
| Your Dishwasher is not switched on. | Switch your Dishwasher on by pressing the On/Off button. | |
| Fuse blown. | Check your indoor fuses. | |
| Water inlet tap is closed. | Turn on the water inlet tap. | |
| Your Dishwasher door is open. | Close the Dishwasher door. | |
| Water inlet hose and machine filters are clogged. | Check the water inlet hose and machine filters and make sure they are not clogged. | |
| Water remains inside the machine. | Water drain hose is clogged or twisted. | Check the drain hose, then either clean or untwist it. |
| The filters are clogged. | Clean the filters. | |
| The programme is not finished yet. | Wait until the programme is finished. | |
| Machine stops during washing. | Power failure. | Check mains power. |
| Water inlet failure. | Check water tap. | |
| Shaking and hitting noises are heard during a wash operation. | The spray arm is hitting the dishes in the lower basket. | Move or remove items blocking the spray arm. |
| Partial food wastes remain on the dishes. | Dishes placed incorrectly, sprayed water not reaching affected dishes. | Do not overload baskets. |
| Dishes leaning each another. | Place dishes as instructed in the section on loading your dishwasher. | |
| Not enough detergent used. | Use the correct amount of detergent, as instructed in the programme table. | |
| Wrong wash programme selected. | Use the information in the programme table to select the most appropriate programme. | |
| Whitish stains remains on dishes. | Not enough detergent used. | Use the correct amount of detergent, as instructed in the programme table. |
| Rinse aid dosage and/or water softener setting set too low. | Increase rinse aid and/or water softener level. | |
| Dishes do not dry. | Drying option is not selected. | Select a programme with a drying option. |
| Rust stains form on the dishes. | High level of salt in wash water. | Adjust the water hardness level using water hardness table. |
| Detergent remains in the detergent compartment. | Detergent was added when the detergent compartment was wet. | Make sure detergent compartment is dry before use. |