Connection The handset does not switch on! |
- Charge the battery.
- Check the charger connections.
- Use only SUPPLIED RECHARGEABLE BATTERIES.
|
| The phone does not work at all. |
- Make sure adaptor and phone cord are connected properly.
- Check batteries are fully charged and installed properly.
- This phone does not work during power failure.
|
| Communication is lost during a call! |
- Charge the SUPPLIED RECHARGEABLE BATTERIES.
- Move closer to the base station.
|
| Poor audio quality |
- Move closer to the base station.
- Move base station at least one metre away from electrical appliances.
|
| No dialling tone |
- Check the connections.
- Reset the phone: unplug and plug back in the mains.
|
| The Š is blinking. |
- Move closer to the base station.
- Check battery level.
- Register the handset to the base station.
|
| The š appears. |
- Replace the batteries with new ones (use only rechargeable batteries).
|
Set-up Caller ID does not work properly. |
- Check with your local phone company that CID service is subscribed to.
- Let the phone ring at least once before answering.
|
| The Call Waiting call cannot be answered. |
- Check with your local phone company and select the correct recall duration.
|
| The handset displays nothing, but only the Š is blinking. |
- Try again by disconnecting and connecting the base station power supply and follow the procedure to register a handset (see Section 3.5).
- Remove and place back the handset batteries.
|
Sound Handset does not ring! |
- Increase the volume.
- Make sure adaptor and phone cord are connected properly.
- Move handset closer to the base unit.
- Make sure handset ringer is turned on.
|
| Caller does not hear me! |
- Microphone may be muted: During a call, press ţ.
|
| Noise interference on your radio or television |
- Move the power adaptor or base station as far away as possible.
|
Product behaviour Caller Line Identification (CLI) service does not work |
- Check your subscription with your network operator.
|
| A phonebook entry cannot be stored |
- Delete an entry to free memory.
|
| The handset is unable to register |
- Make sure Š has been pressed for three seconds.
- Each base can only register up to four handsets.
- Each handset can only be registered to one base.
|
| I forget my PIN |
- Press Ť
- Press 0
- Press ##**793
- Your phone will reset to its default settings and you can get the default PIN of 0000. Phonebook records will not be erased.
|
Answering Machine The answering machine does not record calls. |
- Make sure answering machine is connected to the power adaptor, and the power adaptor is plugged into mains supply which is switched on.
- Check if the answering machine memory is full. If so, delete some or all messages.
- Try switching off the power at the main socket, and then turn it on again after 1 minute.
|
| Unable to perform remote operation |
- Make sure you entered the correct remote access code.
- Use a touch-tone phone.
|