Power ON and OFF Modes

Press the ⏻ button on the Control Panel or POWER ON button on the remote control to turn on the monitor. The monitor's power LED indicates the current status of the monitor. Please refer to the following table for information about the power indicator.

Power indicator status and lighting pattern

Condition	Recovery
Glowing blue	Normal	1. Turn on the monitor by the remote control or the monitor button. 2. Send an AV signal input to the monitor.
Blinking green*1	Under any of the conditions below, no input signal has been detected by the monitor during the period of time you set: • The monitor is using an Option Board*2. • [USB POWER] is set to [ON]. • [SLOT POWER] is set to [ON]. • [POWER CONTROL LINK] of [CEC] is set to [ENABLE]. • [DisplayPort VERSION] is set to [1.2 MST] or [1.4 MST]. • [QUICK START] is [ENABLE].
Glowing amber	No AV signal input has been detected by the monitor during the period of time you set. (with network signal input)
Blinking amber	No AV signal input has been detected by the monitor during the period of time you set. (no network signal input)
Glowing red	Turn off the monitor by the remote control or the monitor button.	Turn on the monitor by the remote control or the monitor button.

*1 : Time setting for auto power save is available at [POWER SAVE SETTINGS] (See page 101).
*2 : [SLOT POWER] is [ON] or [AUTO]. NOTE: • The blue power indicator that the monitor is powered on and functioning normally can be turned off in the monitor’s OSD menu options. See page 106.
• If the indicator is blinking red in a combination of long and short durations, a certain failure might have occurred. Please contact your supplier.
The Main Power switch must be in the ON position in order to power up the monitor using the POWER ON button on the remote control or the ⏻ button on the Control Panel.