Brand: KENWOOD
Category: Refrigerator
Document Type: Manual
Language: EN
Manual for KNF60X18
Uploaded: Nov. 21, 2025, 9:22 p.m.
Warranty Information
Refer to the documentation provided by your retailer for specific warranty information.
Switching on your unit: Connect the mains cable, then press and hold the power button. The internal temperature is controlled by an electronic panel. Press the °C button to set the fridge temperature between 2-8°C. The freezer temperature defaults to -18°C and cannot be manually adjusted. Allow 24 hours for the unit to cool sufficiently before filling with food. Use a special fridge/freezer thermometer to verify temperatures (-18°C or lower for freezer, 0-8°C for fridge).
Super freeze mode: Press °C to activate. A light will illuminate. The mode deactivates automatically after 52 hours or when switched off.
Holiday mode: For periods away, select holiday mode by pressing °C. A light will illuminate, and the fridge temperature will set to 15°C. Do not store food in the fridge during this mode. Switch off by pressing °C until the light extinguishes.
Super freeze mode: Press °C to activate. A light will illuminate. The mode deactivates automatically after 52 hours or when switched off.
Holiday mode: For periods away, select holiday mode by pressing °C. A light will illuminate, and the fridge temperature will set to 15°C. Do not store food in the fridge during this mode. Switch off by pressing °C until the light extinguishes.
Troubleshooting and error codes
| Problem | Possible Cause | Solution |
|---|---|---|
| The unit does not operate | The unit is not plugged in. | Ensure the unit is plugged into a suitable socket. |
| The compressor is not running | The unit is not switched on. | Press and hold the power button to turn on. |
| Internal temperature is too high | The doors are not closed properly. | Check door seals and ensure they are clean and free from obstructions. |
| The unit has recently been switched on. | Allow up to 24 hours for the unit to reach the correct temperature. | |
| The unit is located near a heat source or in direct sunlight. | Reposition the unit away from heat sources and direct sunlight. | |
| The temperature setting is incorrect. | Adjust the temperature setting. | |
| Excessive noise | The unit is not level. | Adjust the levelling feet at the front of the unit. |
| The unit is touching surrounding cabinets. | Ensure adequate clearance around the unit. | |
| Water on the floor | The drain hole is blocked. | Clean the drain hole at the back of the unit. |
| Condensation on the outside of the unit | High humidity in the room. | Wipe off any moisture residue. If the problem continues, contact a qualified technician. |