Brand: Haier
Category: Washing Machines
Document Type: Manual
Language: EN
Manual for HWM70-918NZP
Uploaded: Nov. 21, 2025, 9 p.m.
Warranty Information
None
1. Power On/Off: Press the "Power" button to turn the machine on or off. The machine will automatically shut off after 5 minutes if "Start/Pause" is not pressed.
2. Start/Resume: Press the "Start/Pause" button to begin the wash cycle or to resume after a pause.
3. Program Selection: Use the "Program" button to cycle through available wash programs (Normal, Standard, Strong, Soft, Wool, Tub Dry, Quick, Memory). The indicator light will show the selected program.
4. Water Level: Use the "Water Level" button to select the appropriate water level. For some programs, the machine automatically detects the water level.
5. Reserve Water: The "Reserve Water" option allows you to keep rinse water for later use.
6. Delay Wash: The "Delay" button allows you to set a delayed start time for the wash cycle.
7. Lid Operation: Ensure the top lid is closed for the machine to operate. It will stop and alarm if opened during spinning.
8. Finish: The machine automatically cuts off power after washing is complete.
Troubleshooting and error codes
| Phenomena | The reason | How to settle |
|---|---|---|
| The digitron displays E0. | The top lid is open during reserve procedure. | Close the top lid. |
| The drainage cannot work, or is too slow. The digitron displays E1. | Is the drain hose put down? Is the drain hose blocked? |
Put down the drain hose. Open and close the top lid once. Clean the foreign material. Open and close the top lid once. |
| It stops running in midway. The digitron displays E2. | The top lid is not closed. | Close the top lid. |
| The safety switch acts, and the spinning cannot work. The digitron displays E3. | Are the laundries put slantingly? Is the machine slanting? |
Reorder the laundries. Close the top lid. Place the machine horizontally, open and close the top lid once. |
| The water filling does not work, or is slow, the digitron displays E4. | Is the water tap opened, or is there water supply failure? Is the water inlet valve blocked? Is the water pressure too low? |
Open the water tap. Open and close the top lid once. Clean the water inlet valve then open and close the top lid once. Use after the water pressure is normal. |
| The digitron displays E6. | The water level sensor is bad. | Please contact the after-sales service department. |
| The machine does not act | Not wash Is there power failure? Is the power plug inserted tightly? Is the water level reached preset position? |
Please use it when there's power supply. Insert the power plug tightly. Fill water to the preset position. |
| Not spin Is the power plug inserted tightly? Is the top lid closed reliably? Are the laundries set flat? |
Insert the power plug tightly. Close the top lid. Set the laundries flat. |
|
| There is abnormal sound inside the machine | Is the machine slanting? Are the laundries put slantingly in spinning? Are there any foreign materials? |
Adjust the machine to be even Reorder the laundries and close the top lid. Remove the foreign materials. |
| The water tap leaks | Is the screw of the jointer of water inlet hose loose or awry? | Fasten the screw of the jointer properly. |