Brand: Haier
Category: Dryers
Document Type: Manual
Language: EN
Manual for HD80-01-U/HD80-01ME-U
Uploaded: Nov. 21, 2025, 7:01 p.m.
- BEFORE USE: Ensure the device is installed correctly, the environment is dry and ventilated, and keep away from flammable substances.
- USING THE DEVICE: Select the appropriate drying program and functional options. Load laundry evenly, do not overload, and ensure it's spun dry. Start the dryer and it will stop automatically.
- MAINTENANCE: Clean the lint screen after each cycle. Empty the water collection tank regularly. Clean the drum and condenser monthly.
- TROUBLESHOOTING: Refer to the display codes and troubleshooting table for common issues and solutions. Contact service if problems persist.
Troubleshooting and error codes
| PROBLEM | CAUSES | SOLUTIONS |
|---|---|---|
| Tumble dryer fails to operate. | - Poor connection to the power supply. - Power failure. - No drying program is set. - Device has not been switched on. |
Check connection to the power supply. Check the power supply. Make sure a drying program has been set. Make sure the device is switched on. |
| Tumble dryer fails to operate and the display shows "End". | - The water collection tank is full. - The tumble dryer door is not properly closed. |
Empty the water collection tank. Close the tumble dryer door properly. |
| Drying time is too long and the results are not satisfactory. | - The laundry has reached the condition defined by the program setting. - There is no laundry in the drum. - The program setting is not correct. - The filter screen has not been cleaned. - The condenser is blocked. -The tumble dryer is overloaded. - The laundry is too wet. - The vent duct is blocked. |
Check if your program setting is appropriate. Check if there's laundry in the drum. Make sure the program is set correctly. Clean the filter screen. Clean the condenser. Reduce the amount of laundry in the drum. Spin the laundry properly before drying. Check the vent duct and unblock it. |
| Remaining time on the display stops or skips. | The automatic adjustment is a normal operation. | The automatic adjustment is a normal operation. |