Brand: Electrolux
Category: Refrigerator
Document Type: Manual
Language: EN
Manual for ENN2901AOW
Uploaded: Sept. 12, 2025, 4:15 a.m.
Warranty Information
Information about warranty is not explicitly stated, but typical manufacturer warranties are 24 months.
SWITCHING ON
Insert the plug into the wall socket. Turn the Temperature regulator clockwise to a medium setting.
SWITCHING OFF
To turn off the appliance, turn the Temperature regulator to the "O" position.
TEMPERATURE REGULATION
The temperature is automatically regulated. To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings to obtain the minimum coldness.
• turn the Temperature regulator toward higher settings to obtain the maximum coldness.
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping in mind that the tempera-ture inside the appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continu-ously causing frost or ice on the evaporator. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy con-sumption.
Insert the plug into the wall socket. Turn the Temperature regulator clockwise to a medium setting.
SWITCHING OFF
To turn off the appliance, turn the Temperature regulator to the "O" position.
TEMPERATURE REGULATION
The temperature is automatically regulated. To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings to obtain the minimum coldness.
• turn the Temperature regulator toward higher settings to obtain the maximum coldness.
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping in mind that the tempera-ture inside the appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continu-ously causing frost or ice on the evaporator. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy con-sumption.
Troubleshooting and error codes
| Problem | Possible cause | Solution |
|---|---|---|
| The appliance does not operate. The lamp does not operate. | The appliance is switched off. | Switch on the appliance. |
| The mains plug is not con-nected to the mains socket correctly. | Connect the mains plug to the mains socket correctly. | |
| The appliance has no pow-er. There is no voltage in the mains socket. | Connect a different electrical appliance to the mains sock-et. Contact a qualified electri-cian. | |
| The lamp does not work. | The lamp is in stand-by. | Close and open the door. |
| The lamp is defective. | Refer to "Replacing the lamp". | |
| The compressor op-erates continually. | The temperature is not set correctly. | Set a higher temperature. |
| The door is not closed cor-rectly. | Refer to "Closing the door". | |
| The door has been opened too frequently. | Do not keep the door open longer than necessary. | |
| The product temperature is too high. | Let the product temperature decrease to room tempera-ture before storage. | |
| The room temperature is too high. | Decrease the room temper-ature. | |
| Water flows on the rear plate of the re-frigerator. | During the automatic de-frosting process, frost de-frosts on the rear plate. | This is correct. |
| Water flows into the refrigerator. | The water outlet is clogged. | Clean the water outlet. |
| Products prevent that wa-ter flows into the water col-lector. | Make sure that products do not touch the rear plate. | |
| Water flows on the ground. | The melting water outlet does not flow in the evapo-rative tray above the com-pressor. | Attach the melting water outlet to the evaporative tray. |
| The temperature in the appliance is too low. | The temperature regulator is not set correctly. | Set a higher temperature. |
| The temperature in the appliance is too high. | The temperature regulator is not set correctly. | Set a lower temperature. |
| The door is not closed cor-rectly. | Refer to "Closing the door". | |
| The product temperature is too high. | Let the product temperature decrease to room tempera-ture before storage. | |
| The temperature in the refrigerator is too high. | Many products are stored at the same time. | Store less products at the same time. |
| There is no cold air circula-tion in the appliance. | Make sure that there is cold air circulation in the appli-ance. | |
| The temperature in the freezer is too high. | Products are too near to each other. | Store products so that there is cold air circulation. |
| There is too much frost. | Food is not wrapped cor-rectly. | Wrap the food correctly. |
| The door is not closed cor-rectly. | Refer to "Closing the door". | |
| The temperature regulator is not set correctly. | Set a higher temperature. |