Brand: Electrolux
Category: Dryer
Document Type: Manual
Language: EN
Manual for EDP2074PDW
Uploaded: Sept. 12, 2025, 4:29 a.m.
Warranty Information
24-month warranty against manufacturing defects for domestic use in Australia and New Zealand.
Starting a Programme: Prepare and load laundry, select program and options, then press Start/Pause. For delay start, set the delay time and press Start/Pause to begin countdown. Programme End: Appliance signals completion with sound and indicators. It enters a crease guard phase for 30 minutes. Remove laundry promptly for best results. Auto Stand-By: The appliance deactivates after 5 minutes of inactivity or after the programme ends to save energy.
Troubleshooting and error codes
| Problem | Possible solution |
|---|---|
| You cannot activate the appliance. | Make sure that the mains plug is connected to the mains socket. Check fuse in fuse box (domestic installation). |
| The programme does not start. | Press Start/Pause. Make sure that the appliance door is closed. |
| The appliance door does not close. | Make sure that the installation of the filter is correct. Make sure that the laundry does not catch between the appliance door and the rubber seal. |
| The appliance stops during operation. | Make sure that the water container is empty. Press Start/Pause to start the programme again. |
| The display shows a long programme duration. | Follow guide in program table depending on size and type of load. Make sure that the filter is clean. The laundry is too wet. Spin the laundry in the washing machine again. Make sure that the room temperature is not too warm. |
| The display shows a short programme duration. | Set the Time Drying or the Extra Dry programme. |
| The display shows Err. | If you want to set a new programme, deactivate and activate the appliance. Make sure that the options are applicable to the programme. |
| The display shows E51) | Deactivate and activate the appliance. Start a new programme. If the problem occurs again, contact the Service. |