Brand: Agfa
Category: Camera
Document Type:
Language: EN
Manual for DC-733s
Uploaded: Aug. 9, 2025, 11:36 p.m.
Turning Power On and Off: Press the POWER button to turn on the camera in REC mode (lens extends, LED lights green) or PLAYBACK mode (image displays on LCD). Press the POWER button again to turn off.
Power Saving Function: The LCD monitor automatically turns off after 1 minute of inactivity. Press any button (except POWER) to turn it back on. Complete power off occurs after another minute. Restore power by pressing POWER or PLAYBACK buttons.
Changing the Mode: Switch between REC and PLAYBACK modes by pressing the PLAYBACK button. Select REC modes like Program, Movie, Voice REC, or Q Mode using the MODE button and the four-way control.
Using the Menus: Navigate REC and SETUP menus using the MENU button and four-way control to adjust settings like Resolution, Quality, White Balance, ISO, Exposure, etc.
Troubleshooting and error codes
| Problem | Cause | Solution |
|---|---|---|
| Power does not turn on. | Battery is inserted in the wrong direction. | Reload battery in the correct direction. |
| Batteries are dead. | Replace or recharge batteries. | |
| The battery compartment door is open. | Make sure the battery compartment door is securely closed. | |
| The camera does not take pictures. | The flash is charging. | Wait for the flash to charge. |
| Memory is full. | Insert a new memory card. | |
| Memory card is not formatted correctly. | The card may be defective, use a new card. | |
| Image is not recorded when the shutter button is pressed. | The flash is charged. | Wait for the flash to charge. |
| Memory is full. | Insert a new memory card. | |
| The flash does not fire. | Flash is set to OFF. | Set the flash to any mode except off. |
| Image is blurry or out of focus. | The camera was moving when the image was captured. | Hold the camera steady when shooting picture. |
| The subject was beyond the range within which the camera can focus. | Turn the Macro mode on if the subject is within 15 cm or 40 cm. Do not use Macro mode when shooting distant subjects. | |
| Image is not displayed on the LCD monitor. | A memory card with non-DCIF images (recorded with other camera) is loaded. | This camera cannot display non-DCIF images. |
| Recorded images are not saved in memory. | The camera was turned off / powered down before the image was stored in memory. | If the battery low indicator appears on the LCD monitor, replace the battery immediately. |
| Cannot transfer images to a computer after connecting the USB cable. | USB driver is not installed. | Install the USB driver before you connect the camera to a computer / turn the camera on. |
| Card error | The memory card format may not be correct. | Re-format the memory card to the FAT format using a card reader in Windows. |