Brand: AEG
Category: Washer/Dryer
Document Type: Manual
Language: EN
Manual for L8WBE68SI
Uploaded: April 20, 2026, 8:12 p.m.
Warranty Information
Please refer to the warranty card for detailed warranty information.
Daily Use - Washing Only: Select a programme using the programme dial. Adjust temperature and spin speed if needed. Press Start/Pause to begin.
Daily Use - Washing & Drying: Select a programme, then select the desired dryness level using the 'Dry touch button'. Press Start/Pause.
Daily Use - Drying Only: Select the 'Mode - Dry' option. Choose an automatic dryness level or time dry. Press Start/Pause.
Care and Cleaning: Regularly clean the drum, detergent dispenser, and drain pump. Follow specific instructions for each part.
Troubleshooting: Refer to the 'Possible failures' section for common problems and solutions. Check error codes displayed on the screen and consult the manual for their meaning.
Troubleshooting and error codes
| Problem | Possible solution |
|---|---|
| The programme does not start. | • Make sure that the mains plug is connected to the mains socket. • Make sure that the appliance door is closed. • Make sure that there is no damaged fuse in the fuse box. • Make sure that the Start/Pause ▷|| has been touched. • If the delay start is set, cancel the setting or wait for the end of countdown. • Deactivate the Child Lock function if it is on. • Check the position of the knob on the selected programme. |
| The appliance does not fill with water properly. | • Make sure that the water tap is open. • Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. • Make sure that the water tap is not clogged. • Make sure that the inlet hose has no kinks, damages or bends. • Make sure that the connection of the water inlet hose is correct. • Make sure that the filter of the inlet hose and the filter of the valve are not clogged. Refer to 'Care and cleaning'. |
| The appliance fills with water and drains immediately | • Make sure that the drain hose is in the correct position. The hose may be positioned too low. Refer to "Installation instruction". |
| The appliance does not drain the water. | • Make sure that the sink spigot is not clogged. • Make sure that the drain hose has no kinks or bends. • Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to "Care and cleaning". • Make sure that the connection of the drain hose is correct. • Set the drain programme if you set a programme without drain phase. • Set the drain programme if you set an option which ends with water in the tub. |
| The spin phase does not operate or the washing cycle lasts longer than usual. | • Set the spin programme. • Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to "Care and cleaning". • Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems. |
| There is water on the floor. | • Make sure that the couplings of the water hoses are tight and there is not water leakages. • Make sure that the water inlet hose and the drain hose have no damages. • Make sure you use the correct detergent and the correct quantity of it. |