Manual for FAVORIT

Brand: AEG

Category: Home Appliances

Document Type: Manual

Language: EN

Uploaded: April 20, 2026, 7:48 p.m.

Warranty Information

This manual does not contain warranty information.

Dishwasher Operation Summary

Getting Started: - Ensure the dishwasher is properly installed with electrical and water connections made. - Load dishes according to the instructions on pages 10-12, ensuring spray arms are not blocked. - Add detergent to the dispenser (page 14) and salt to the water softener (page 16). - Add clear-rinse agent to its dispenser (page 14).

Selecting a Programme: - Turn the programme selector switch to the left or right to choose between 6 settings (page 6). - Settings 1 is an auto reset; 2-6 are wash programmes. - Pull the switch outwards to start the selected programme. The quantity indicator will light up.

During Operation: - A red line on the indicator panel shows the progress of the programme. - The machine switches off automatically when the programme is finished.

Ending Operation: - Press the selector switch to switch off (the indicator light will go out). - Close the water tap, unplug or switch off the main switch. - For best drying results, leave dishes in the racks with the door ajar for a short while after the cycle finishes.

Programme Interruption/Change: - To interrupt or change programmes, press the selector switch in, select "1", and pull the switch out again. The programme indicator will reset to "0", allowing a new programme to be selected.

Troubleshooting and error codes

Problem	Possible Cause	Solution
Dishes are not clean	Incorrect detergent used or insufficient amount Detergent container not closed properly Incorrect loading of the dishwasher Dishes blocking the spray arms Pre-rinse programme not used for heavily soiled dishes Filter not cleaned or replaced correctly	Use correct dishwasher detergent in sufficient quantity. Close detergent container lid. Load dishes as instructed. Ensure spray arms can rotate freely. Use programme "6" for heavily soiled dishes. Clean the filter and replace it properly.
Dishes are not sparkling	Incorrect clear-rinse agent used Clear-rinse agent dispenser empty Insufficient common salt used for water softener	Use a suitable clear-rinse agent. Refill the clear-rinse agent (check indicator window). Add sufficient common salt for each programme.
Dishwasher doesn't start	Door not properly closed Water tap not opened Plug not connected or main switch off Programme selector not operated correctly Selector switch not pulled out far enough Fuse blown	Close door properly and open water tap. Connect plug or switch on main switch. Operate programme selector correctly. Pull selector switch out until red line leaves "0". Check and replace fuse if necessary.
Dishes are not sprayed with water	Thermal-overload protection may have responded, switching off the circulation pump.	Refer to page 8 for motor protection information.