Manual for 4Safety PRECISION STEAM IRON DB61XX

Brand: AEG

Category: Home Appliances

Document Type: Manual

Language: EN

Uploaded: April 20, 2026, 7:57 p.m.

Warranty Information

This product is intended for domestic use only and the manufacturer cannot accept liability for damage caused by improper use.

First Use: Remove adhesive, clean with a damp cloth, rinse water tank. Temporary vapours may occur.

Filling: Ensure plug is removed. Turn selector to '0', open cover, fill tank to max level, close cover.

Power On: Plug in, indicator light turns on. Select temperature. Light turns green when ready.

Spray/Steam: Ensure tank is at least 1/4 full for spray (press button multiple times). Ensure tank is at least 1/2 full for steam jet (press button multiple times).

Vertical Steaming: Hang item, hold iron 10-20 cm away, press steam jet button.

Auto-OFF: Turns off after 30 seconds if left unattended on soleplate/side, or after 8 minutes on heel. Begin ironing to reactivate. Indicator flashes yellow, beeps 6 times before shutdown.

Troubleshooting and error codes

Problem	Possible cause	Solution
Soleplate is not heating even though iron is turned on.	Connection problem	Check main power supply cable, plug and outlet.
	Temperature control is in MIN position.	Select adequate temperature.
Iron does not produce steam.	Not enough water in tank.	Fill water tank (see "Getting started", no 2).
	Steam control is selected in non-steam position.	Set steam control between positions of minimum steam and maximum steam (see "Ironing chart").
Spray function does not work.	Selected temperature is lower than that specified to use with steam.	Increase temperature to at least ■■.
	Not enough water in tank.	Fill water tank (see "Getting started", no 2).
Steam jet and vertical steam jet function does not work.	Steam jet function was used very frequently within a short period.	Put iron on horizontal position and wait before using steam jet function.
	Iron is not hot enough.	Adjust the proper temperature to steam ironing (up to ■■). Put iron in vertical position and wait until temperature indicator light turns off.