Manual for IKX64301CB

Manual for IKX64301CB

Brand: AEG

Category: Hobs

Document Type: Manual

Language: EN

Uploaded: April 20, 2026, 8 p.m.

Warranty Information

None

Welcome to AEG!

Thank you for choosing our appliance.
Get usage advice, brochures, trouble shooter, service and repair information: www.aeg.com/support

CONTENTS

  1. SAFETY INFORMATION
  2. SAFETY INSTRUCTIONS
  3. INSTALLATION
  4. PRODUCT DESCRIPTION
  5. DAILY USE
  6. HINTS AND TIPS
  7. CARE AND CLEANING
  8. TROUBLESHOOTING
  9. TECHNICAL DATA
  10. ENERGY EFFICIENCY
  11. ENVIRONMENTAL CONCERNS

Troubleshooting and error codes

Problem Possible cause Remedy
You cannot activate or operate the hob. The hob is not connected to an electrical supply or it is connected incorrectly. Check if the hob is correctly connected to the electrical supply.
The fuse is blown. Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician.
You did not set the heat setting for 10 seconds. Activate the hob again and set the heat setting in less than 10 seconds.
You touched 2 or more sensor fields at the same time. Touch only one sensor field.
Pause operates. Refer to "Pause".
There is water or fat stains on the control panel. Clean the control panel.
You can hear a constant beep noise. The electrical connection is incorrect. Disconnect the hob from the electrical supply. Ask a qualified electrician to check the installation.
An acoustic signal sounds and the hob deactivates. You put something on one or more sensor fields. Remove the object from the sensor fields.
An acoustic signal sounds when the hob is deactivated. You put something on the sensor field. Remove the object from the sensor field.
The hob deactivates. The zone is not hot because it operated only for a short time or the sensor is damaged. If the zone operated sufficiently long to be hot, speak to an Authorised Service Centre.
Residual heat indicator does not come on.
Hob²Hood does not work. You covered the control panel. Remove the object from the control panel.
Automatic Heat Up does not operate. The highest heat setting is set. The highest heat setting has the same power as the function.
The heat setting changes between two levels. The zone is hot. Let the zone become sufficiently cool.
Power management operates. Refer to "Daily use".
The control panel becomes hot to the touch. The cookware is too large or you put it too close to the control panel. Put large cookware on the rear zones, if possible.
There is no sound when you touch the panel sensor fields. The sounds are deactivated. Activate the sounds. Refer to "Daily use".
L comes on. Child Safety Device or Lock operates. Refer to "Daily use".
F comes on. There is no cookware on the zone. Put cookware on the zone.
E and a number come on. The cookware is unsuitable. Use cookware suitable for induction hobs. Refer to "Hints and tips".
The diameter of the bottom of the cookware is too small for the zone. Use cookware with correct dimensions. Refer to "Technical data".
There is an error in the hob. Deactivate the hob and activate it again after 30 seconds. If E comes on again, disconnect the hob from the electrical supply. After 30 seconds, connect the hob again. If the problem continues, speak to an Authorised Service Centre.
Privacy Policy