Brand: AEG
Category: Cooktop
Document Type: Manual
Language: EN
Manual for HK955070FB
Uploaded: April 20, 2026, 7:50 p.m.
Warranty Information
Refer to the warranty conditions in the provided warranty booklet for details.
- **Switching On/Off:** Touch the on/off sensor field for 1 second.
- **Automatic Switch Off:** The appliance automatically switches off if all cooking zones are deactivated, heat setting is not set after activation, something is spilled on the control panel, or a cooking zone is not deactivated or its heat setting is not changed.
- **Setting Heat:** Touch the control bar at the desired heat setting and adjust as needed.
- **Outer Rings:** Touch the sensor field to activate the outer ring.
- **Automatic Heat Up:** Activate the function by touching A and selecting the heat setting.
- **Timer (Countdown):** Select the cooking zone, set the timer with +/-, and start the countdown.
- **CountUp Timer (Count-up):** Select the cooking zone, activate the timer with , and the time will count up.
- **Hob Timer:** Use the timer as a hob timer when cooking zones are switched off.
- **STOP+GO:** This function sets all cooking zones to the lowest setting.
- **Lock:** Locks the control panel to prevent accidental changes.
- **Child Safety Device:** Prevents accidental operation of the appliance.
- **OffSound Control:** To enable/disable appliance sounds.
Troubleshooting and error codes
| Problem | Possible cause | Solution |
|---|---|---|
| The appliance cannot be switched on or operated | The appliance is not plugged into the mains socket or is not correctly installed. | Check that the appliance is correctly connected to the mains socket (see connection diagram). |
| Two or more touch keys have been pressed simultaneously. | Press only one touch key at a time. | |
| The STOP+GO function is active. | Refer to the "Daily Use" chapter. | |
| There is water or grease splatters on the control panel. | Clean the control panel. | |
| A signal sounds and the appliance switches off. | One or more touch keys have been covered. | Remove the object from the touch keys. |
| A signal sounds when the appliance is switched off. | Something has been placed on the touch key. | Remove the object from the touch keys. |
| The appliance switches off. | The cooking zone is not hot because it was used only briefly. | If the cooking zone does not heat up sufficiently after a long time, contact customer service. |
| The residual heat indicator does not light up. | The cooking zone is hot. | Allow the cooking zone to cool down sufficiently. |
| The Automatic Heat Up function does not start. | The highest heat setting is selected. | The highest heat setting has the same power as the Automatic Heat Up function. |
| The outer ring cannot be activated. | The cookware is too large or is placed too close to the control panel. | Place larger cookware on the rear cooking zones if necessary. |
| The sensor fields become warm. | The signals are switched off. | Activate the signals (see "Switching sounds on/off"). |
| No audible signal sounds when you touch the control panel sensor fields. | The Automatic Switch Off function is active. | Switch the appliance off and on again. |
| lights up. | The Child Safety Device or key lock is active. | Refer to the "Daily Use" chapter. |
| lights up. | There is a fault in the appliance. | Disconnect the appliance from the power supply for a while. Switch off the circuit breaker in your home's electrical system. Switch on again. If lights up again, contact Customer Service. |